|
Step Global |
|---|
GNSS (Global Navigation Satellite System) signal distribution involves amplifying, repeating, and distributing signals to various receivers, devices or across different locations. This distribution allows multiple devices to access GNSS signals from a single antenna, because of this it is often more cost-effective to distribute the signal as opposed to installing individual antennas for each device. Signal distribution is often used in applications where location or timing data is required but GNSS signals are limited or obstructed. This signal obstruction can occur in urban environments such as cities where large buildings make accessing satellite signals challenging.
Step Global provides solutions for all your GNSS signal distribution requirements, we provide GNSS signal splitters with outputs ranging from 2-32, we also supply signal amplifiers, attenuators, combiners, filters, and repeaters. We also provide a range of products for UHF and RFID signal distribution.
Product Code: MS12
Brand: GPS Source
This is a military qualified GPS splitter with one-input and two outputs. It typically finds application where an input from an active GPS roof antenna is split evenly between two receiving GPS units.The MS12 can be configured to pass DC from an RF output (J2) to the antenna input port in order to power an active GPS antenna on that port. The remaining RF output would feature a 200 Ohm DC load...
Product Code: MS14
Brand: GPS Source
This is a military qualified MS14 GPS splitter with one-input and four-outputs. It typically finds application where an input from an active GPS roof antenna is split evenly between four receiving GPS units. The MS14 can be configured to pass DC from an RF output (J2) to the antenna input port (J1) in order to power an active GPS antenna on that port. The remaining RF outputs (J3, J4, and J5)...
Product Code: MS18
Brand: GPS Source
This is a military qualified MS18 GPS splitter with one-input and eight-outputs. It typically finds application where an input from an active GPS roof antenna is split evenly between eight receiving GPS units. The MS18 can be configured to pass DC from an RF output (J2) to the antenna input port (J1) in order to power an active GPS antenna on that port. The remaining RF outputs (J3 thru J9)...
