Corner Reflector, 12 dBi, with N-female connector/mounting hardware, (1.8-2.0 GH

Mobile Mark’s high frequency Corner Reflector antennas are useful for applications such as surveillance work, 1.8/1.9 GHz GSM, and other high frequency applications.

Its unique design features allow the antenna to overcome many of the problems normally associated with higher frequency systems.

These corner reflectors use a half-wavelength element configuration. A unique balun fed design provides high efficiency radiation without skewing of the radiation pattern. The resulting performance provides excellent bandwidth, gain and match over the frequency range.

The connector mechanism exits at the rear of the antenna, allowing easy installation. The mounting bracket attached to antenna allows both horizontal and vertical mounting of the antenna. Each reflector panel measures 7” x 7” (178 mm x 178 mm), providing very low aperture and wind loading. The reflectors are made of aluminum, and weather protected with a tough powder-coat finish.

The radiating elements are weather proSpecifications Frequency: See above Gain: See above VSWR: 2:1 max over range Impedance: 50 Ohm nominal Maximum Power: 200 Watts SCR11 Beamwidth: 50o El, 39o Az SCR12 Beamwidth: 48o El, 38o Az Front-to-Back ratio: 22 dB or better Lightning Protection: DC grounded, external protection recommended Max Wind Velocity: 125+ mph (200 kph) Operating Temp: -40o to +85o C Weight: 2 lbs (1 kg) tected within an ASA radome.

This maintains integrity of the antenna without sacrificing looks or wind loading. Mounting hardware consists of heavy duty U-Bolts for mounting to poles up to 2.5 inches (6.4 cm) in diameter. Custom cable assembles are available from Mobile Mark to facilitate the connection from the antenna to the modem.